Cylinder Head Nuts And Washers

These nuts and washers hold the heads on. The washers are thick so they won't deform under heat and torque. The torque on 10mm nuts is 28 ft. lb. and the 8mm nuts is 18 ft.lb. One trick is to use 3M glue on the bottom of the washers in the rocker area to prevent leaking through the head.

This item is available for:

Type 1 (Bug) applications

Type 2 (Bus) applications

Type 3 (Station Wagon) applications

Type KG (Ghia) applications

Type TH (Thing) applications

Type OR (Off Road) applications

Safari Friction Washers

This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. You should have two per slide.

This item is available for:

Type 2 (Bus) applications

Case Half Washers and Nuts

This is the washer used under the nuts on cases that use an o-ring on the center main studs. Note: If you are using case half sealing nuts do not use these washers.

This item is available for:

Type 1 (Bug) applications

Type 2 (Bus) applications

Type 3 (Station Wagon) applications

Type KG (Ghia) applications

Type TH (Thing) applications

Type OR (Off Road) applications

Washers

This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel.

This item is available for:

Type 1 (Bug) applications

Type 2 (Bus) applications

Type 3 (Station Wagon) applications

Type KG (Ghia) applications

Type TH (Thing) applications

Type OR (Off Road) applications

Aluminum Wheel Washers

These washers are used when you are running an aluminum wheel that just has a flat hole for the lug nut (bolt). Use a concave style nut (bolt) against these washers to hold your wheel on.

This item is available for:

Type OR (Off Road) applications